USN-8714-3: Linux kernel vulnerabilities

In the Linux kernel, the following vulnerability has been resolved: ocfs2/dlm: validate qr_numregions in dlm_match_regions() Patch series "ocfs2/dlm: fix two bugs in dlm_match_regions()". In dlm_match_regions(), the qr_numregions field from a DLM_QUERY_REGION network message is used to drive loops over the qr_regions buffer without sufficient validation. This series fixes two issues: - Patch 1 adds a bounds check to reject messages where qr_numregions exceeds O2NM_MAX_REGIONS. The o2net layer only validates message byte length; it does not constrain field values, so a crafted message can set qr_numregions up to 255 and trigger out-of-bounds reads past the 1024-byte qr_regions buffer. - Patch 2 fixes an off-by-one in the local-vs-remote comparison loop, which uses ' 32 causes out-of-bounds reads past the qr_regions buffer. Add a bounds check for qr_numregions before entering the loops.

In the Linux kernel, the following vulnerability has been resolved: sctp: validate cached peer INIT chunk length in COOKIE_ECHO processing When a listening SCTP server processes a COOKIE_ECHO chunk, the cached peer INIT chunk embedded after the cookie is parsed and its parameters are later walked by sctp_process_init() using sctp_walk_params(). However, the chunk header length of this cached INIT chunk was not validated against the remaining buffer in the COOKIE_ECHO payload. If the length field is inflated, the parameter walk can run beyond the actual received data, leading to out-of-bounds reads and potential memory corruption during later parameter handling (e.g. STATE_COOKIE processing and kmemdup() copies). Add a bounds check in sctp_unpack_cookie() to ensure the cached INIT chunk length does not exceed the available data in the COOKIE_ECHO buffer before it is used.

In the Linux kernel, the following vulnerability has been resolved: ocfs2/dlm: fix off-by-one in dlm_match_regions() region comparison The local-vs-remote region comparison loop uses '<=' instead of '<', causing it to read one entry past the valid range of qr_regions. The other loops in the same function correctly use '<'. Fix the loop condition to use '<' for consistency and correctness.