USN-8922-2: Linux kernel (Azure) vulnerabilities

In the Linux kernel, the following vulnerability has been resolved: vfio/pci: Properly hide first-in-list PCIe extended capability There are cases where a PCIe extended capability should be hidden from the user. For example, an unknown capability (i.e., capability with ID greater than PCI_EXT_CAP_ID_MAX) or a capability that is intentionally chosen to be hidden from the user. Hiding a capability is done by virtualizing and modifying the 'Next Capability Offset' field of the previous capability so it points to the capability after the one that should be hidden. The special case where the first capability in the list should be hidden is handled differently because there is no previous capability that can be modified. In this case, the capability ID and version are zeroed while leaving the next pointer intact. This hides the capability and leaves an anchor for the rest of the capability list. However, today, hiding the first capability in the list is not done properly if the capability is unknown, as struct vfio_pci_core_device->pci_config_map is set to the capability ID during initialization but the capability ID is not properly checked later when used in vfio_config_do_rw(). This leads to the following warning [1] and to an out-of-bounds access to ecap_perms array. Fix it by checking cap_id in vfio_config_do_rw(), and if it is greater than PCI_EXT_CAP_ID_MAX, use an alternative struct perm_bits for direct read only access instead of the ecap_perms array. Note that this is safe since the above is the only case where cap_id can exceed PCI_EXT_CAP_ID_MAX (except for the special capabilities, which are already checked before). [1] WARNING: CPU: 118 PID: 5329 at drivers/vfio/pci/vfio_pci_config.c:1900 vfio_pci_config_rw+0x395/0x430 [vfio_pci_core] CPU: 118 UID: 0 PID: 5329 Comm: simx-qemu-syste Not tainted 6.12.0+ #1 (snip) Call Trace: ? show_regs+0x69/0x80 ? __warn+0x8d/0x140 ? vfio_pci_config_rw+0x395/0x430 [vfio_pci_core] ? report_bug+0x18f/0x1a0 ? handle_bug+0x63/0xa0 ? exc_invalid_op+0x19/0x70 ? asm_exc_invalid_op+0x1b/0x20 ? vfio_pci_config_rw+0x395/0x430 [vfio_pci_core] ? vfio_pci_config_rw+0x244/0x430 [vfio_pci_core] vfio_pci_rw+0x101/0x1b0 [vfio_pci_core] vfio_pci_core_read+0x1d/0x30 [vfio_pci_core] vfio_device_fops_read+0x27/0x40 [vfio] vfs_read+0xbd/0x340 ? vfio_device_fops_unl_ioctl+0xbb/0x740 [vfio] ? __rseq_handle_notify_resume+0xa4/0x4b0 __x64_sys_pread64+0x96/0xc0 x64_sys_call+0x1c3d/0x20d0 do_syscall_64+0x4d/0x120 entry_SYSCALL_64_after_hwframe+0x76/0x7e

In the Linux kernel, the following vulnerability has been resolved: nfsd: fix nfs4_openowner leak when concurrent nfsd4_open occur The action force umount(umount -f) will attempt to kill all rpc_task even umount operation may ultimately fail if some files remain open. Consequently, if an action attempts to open a file, it can potentially send two rpc_task to nfs server. NFS CLIENT thread1 thread2 open("file") ... nfs4_do_open _nfs4_do_open _nfs4_open_and_get_state _nfs4_proc_open nfs4_run_open_task /* rpc_task1 */ rpc_run_task rpc_wait_for_completion_task umount -f nfs_umount_begin rpc_killall_tasks rpc_signal_task rpc_task1 been wakeup and return -512 _nfs4_do_open // while loop ... nfs4_run_open_task /* rpc_task2 */ rpc_run_task rpc_wait_for_completion_task While processing an open request, nfsd will first attempt to find or allocate an nfs4_openowner. If it finds an nfs4_openowner that is not marked as NFS4_OO_CONFIRMED, this nfs4_openowner will released. Since two rpc_task can attempt to open the same file simultaneously from the client to server, and because two instances of nfsd can run concurrently, this situation can lead to lots of memory leak. Additionally, when we echo 0 to /proc/fs/nfsd/threads, warning will be triggered. NFS SERVER nfsd1 nfsd2 echo 0 > /proc/fs/nfsd/threads nfsd4_open nfsd4_process_open1 find_or_alloc_open_stateowner // alloc oo1, stateid1 nfsd4_open nfsd4_process_open1 find_or_alloc_open_stateowner // find oo1, without NFS4_OO_CONFIRMED release_openowner unhash_openowner_locked list_del_init(&oo->oo_perclient) // cannot find this oo // from client, LEAK!!! alloc_stateowner // alloc oo2 nfsd4_process_open2 init_open_stateid // associate oo1 // with stateid1, stateid1 LEAK!!! nfs4_get_vfs_file // alloc nfsd_file1 and nfsd_file_mark1 // all LEAK!!! nfsd4_process_open2 ... write_threads ... nfsd_destroy_serv nfsd_shutdown_net nfs4_state_shutdown_net nfs4_state_destroy_net destroy_client __destroy_client // won't find oo1!!! nfsd_shutdown_generic nfsd_file_cache_shutdown kmem_cache_destroy for nfsd_file_slab and nfsd_file_mark_slab // bark since nfsd_file1 // and nfsd_file_mark1 // still alive ======================================================================= BUG nfsd_file (Not tainted): Objects remaining in nfsd_file on __kmem_cache_shutdown() ----------------------------------------------------------------------- Slab 0xffd4000004438a80 objects=34 used=1 fp=0xff11000110e2ad28 flags=0x17ffffc0000240(workingset|head|node=0|zone=2|lastcpupid=0x1fffff) CPU: 4 UID: 0 PID: 757 Comm: sh Not tainted 6.12.0-rc6+ #19 Hardware name: QEMU Standard PC (i440FX + PIIX, 1996), BIOS 1.16.1-2.fc37 04/01/2014 Call Trace: dum ---truncated---

In the Linux kernel, the following vulnerability has been resolved: s390/cpum_sf: Handle CPU hotplug remove during sampling CPU hotplug remove handling triggers the following function call sequence: CPUHP_AP_PERF_S390_SF_ONLINE --> s390_pmu_sf_offline_cpu() ... CPUHP_AP_PERF_ONLINE --> perf_event_exit_cpu() The s390 CPUMF sampling CPU hotplug handler invokes: s390_pmu_sf_offline_cpu() +--> cpusf_pmu_setup() +--> setup_pmc_cpu() +--> deallocate_buffers() This function de-allocates all sampling data buffers (SDBs) allocated for that CPU at event initialization. It also clears the PMU_F_RESERVED bit. The CPU is gone and can not be sampled. With the event still being active on the removed CPU, the CPU event hotplug support in kernel performance subsystem triggers the following function calls on the removed CPU: perf_event_exit_cpu() +--> perf_event_exit_cpu_context() +--> __perf_event_exit_context() +--> __perf_remove_from_context() +--> event_sched_out() +--> cpumsf_pmu_del() +--> cpumsf_pmu_stop() +--> hw_perf_event_update() to stop and remove the event. During removal of the event, the sampling device driver tries to read out the remaining samples from the sample data buffers (SDBs). But they have already been freed (and may have been re-assigned). This may lead to a use after free situation in which case the samples are most likely invalid. In the best case the memory has not been reassigned and still contains valid data. Remedy this situation and check if the CPU is still in reserved state (bit PMU_F_RESERVED set). In this case the SDBs have not been released an contain valid data. This is always the case when the event is removed (and no CPU hotplug off occured). If the PMU_F_RESERVED bit is not set, the SDB buffers are gone.

In the Linux kernel, the following vulnerability has been resolved: iio: adc: at91: call input_free_device() on allocated iio_dev Current implementation of at91_ts_register() calls input_free_deivce() on st->ts_input, however, the err label can be reached before the allocated iio_dev is stored to st->ts_input. Thus call input_free_device() on input instead of st->ts_input.

In the Linux kernel, the following vulnerability has been resolved: dm thin: make get_first_thin use rcu-safe list first function The documentation in rculist.h explains the absence of list_empty_rcu() and cautions programmers against relying on a list_empty() -> list_first() sequence in RCU safe code. This is because each of these functions performs its own READ_ONCE() of the list head. This can lead to a situation where the list_empty() sees a valid list entry, but the subsequent list_first() sees a different view of list head state after a modification. In the case of dm-thin, this author had a production box crash from a GP fault in the process_deferred_bios path. This function saw a valid list head in get_first_thin() but when it subsequently dereferenced that and turned it into a thin_c, it got the inside of the struct pool, since the list was now empty and referring to itself. The kernel on which this occurred printed both a warning about a refcount_t being saturated, and a UBSAN error for an out-of-bounds cpuid access in the queued spinlock, prior to the fault itself. When the resulting kdump was examined, it was possible to see another thread patiently waiting in thin_dtr's synchronize_rcu. The thin_dtr call managed to pull the thin_c out of the active thins list (and have it be the last entry in the active_thins list) at just the wrong moment which lead to this crash. Fortunately, the fix here is straight forward. Switch get_first_thin() function to use list_first_or_null_rcu() which performs just a single READ_ONCE() and returns NULL if the list is already empty. This was run against the devicemapper test suite's thin-provisioning suites for delete and suspend and no regressions were observed.

In the Linux kernel, the following vulnerability has been resolved: nfsd: handle get_client_locked() failure in nfsd4_setclientid_confirm() Lei Lu recently reported that nfsd4_setclientid_confirm() did not check the return value from get_client_locked(). a SETCLIENTID_CONFIRM could race with a confirmed client expiring and fail to get a reference. That could later lead to a UAF. Fix this by getting a reference early in the case where there is an extant confirmed client. If that fails then treat it as if there were no confirmed client found at all. In the case where the unconfirmed client is expiring, just fail and return the result from get_client_locked().

In the Linux kernel, the following vulnerability has been resolved: ip6_vti: fix incorrect tunnel matching in vti6_tnl_lookup() In vti6_tnl_lookup(), when an exact match for a tunnel fails, the code falls back to searching for wildcard tunnels: - Tunnels matching the packet's local address, with any remote address wildcard remote). - Tunnels matching the packet's remote address, with any local address (wildcard local). However, vti6 stores all these different types of tunnels in the same hash table (ip6n->tnls_r_l) prone to hash collisions. The bug is that the fallback search loops in vti6_tnl_lookup() were missing checks to ensure that the candidate tunnel actually has a wildcard address.