Owner says Claude and Codex altered a 1994 Jeep ECU
First merged summary.
An owner says Claude and Codex used a cheap Arduino to alter a 1994 Jeep engine computer; the smog result is unverified.
Muhammad Zulali says Claude Code diagnosed his 1994 Jeep Cherokee after it failed a smog test and, with an Arduino Nano, read the engine computer over Chrysler SCI. The Cherokee has no OBD2 port. OpenAI’s Codex later stored a small program in EEPROM because the December 1993 computer could not be reflashed. The GPLv3 xj-scanner project was tested on one 4.0L Cherokee. Zulali, who says he is not a mechanic, says the Jeep then passed a California smog test; that result has not been independently checked.
- Parts cost about $15, including a $3 Arduino Nano.
- The diagnostic link ran near 7,800 baud over three wires.
- The work took about a week and briefly switched the fuel pump on.
- A public ChryslerScanner table misread fuel trim until Claude corrected it.
- The GitHub repo had 252 stars and 30 forks; use is at the owner's risk.
- The computer was about four months too early to be reflashable.
What each outlet adds
beyond the shared facts- Cyber Security NewsFuel-pump activation, table correction, and that the result is unverified.
- GBHackersNo OBD2 port, and the computer was too early to reflash.
Coverage
oldest first · one row per article · UTCOwner uses Claude and Codex to run code on a 1994 Jeep ECU
A roughly $15 Arduino setup spoke Chrysler SCI; the owner says the Jeep then passed a California smog test, unverified.
Owner uses Claude and Codex to alter a 1994 Jeep engine computer
He used about $15 of parts on a Chrysler SCI link and says the Cherokee then passed a California smog test.