Owner uses Claude and Codex to run code on a 1994 Jeep ECU
Original title: Claude Cracks 32-Year-Old Jeep ECU Using a $3 Arduino and Reverse Engineers Its Engine Computer
A roughly $15 Arduino setup spoke Chrysler SCI; the owner says the Jeep then passed a California smog test, unverified.
Muhammad Zulali says Claude Code diagnosed a 1994 Jeep Cherokee that failed a smog test and, with a $3 Arduino Nano, read its engine computer over Chrysler SCI. OpenAI’s Codex later stored a small program in EEPROM because the December 1993 computer could not be reflashed. The GPLv3 xj-scanner project was tested on one 4.0L Cherokee. Zulali says he is not a mechanic and the result has not been independently checked.
Unconfirmed: The owner reported the result himself and says some engine claims may be wrong.
- The work took about a week and the parts list came to about $15.
- The link ran near 7,800 baud using three wires from the diagnostic plug.
- Claude briefly switched the fuel pump on, moving beyond read-only access.
- A public ChryslerScanner table misread fuel trim until Claude corrected it.
- The GitHub repo had 252 stars and 30 forks, with use at the owner’s risk.
- 1.Review agent commands before approval, as Anthropic’s Claude Code guide advises.
- Products
- Claude Code
From the original article
3 min read at cybersecuritynews.comA car owner says an AI coding agent helped him read, copy, and then run code inside the engine computer of a 1994 Jeep Cherokee. The work took about a week. He used a $3 Arduino Nano, and the Jeep passed California’s smog test at the end.
By Guru Baran · cybersecuritynews.com
A short excerpt; the article and its images belong to the publisher. Summary, key facts and assessment above are AI-written from the article and can be wrong.